DOMANDA 3930K@ 4.7Ghz sono ok con le settings? :)

[Ramqage]

Salve vorrei qualche parere su cosa cambiare a queste settings o se vanno bene così...IBT Maximum dopo 1 e mezza tocco 86°c...42-44° in idle, vi allego sotto le settings e gli screen di CPU-Z,RealTemp e HWMonitor





Extreme Tweaker Menu
Ai Overclock Tuner: X.M.P
CPU Level Up: Disabled
Bclk freq: 100.000
CPU Strap: 100MHz
ClockGen Full Reset: Enabled
Turbo Ratio: By All Cores
By all cores : 47
CPU Clock Gen Filter:Enable
Memory Freq: DDR3-2400mHz
Extreme Tweaking: Disabled
EPU Power Saving Mode: Disabled
Extreme OV: Disable
Bclk Skew: Auto
CPU Vcore : Manual Mode
CPU Vcore Voltage: 1.380
VTT CPU Voltage: 1.1
2nd VTTCPU Voltage: 1.05
CPU VCCSA Manual Voltage: 1.1
DRAM V (A, B): 1.65
DRAM V (C, D): 1.65
CPU PLL Voltage: 1.65
PCH Voltage: Auto
VTTDR Voltage (A, B): Auto
VTTDR Voltage (C, D): Auto
CPU Spread Spectrum: Disabled
PCIe Spread Spectrum: Disabled

DRAM Timing Control
Rampage Tweak : Mode
CAS: 11
RAS to CAS Delay: 14
RAS Pre Time: 14
RAS ACT Time:33
Command Mode: 1

Digi+ Power Control Submenu
CPU Load-Line Calibration(LLC): Very High
CPU current capability: 140%
CPU Voltage Freq: Manual
Fixed frequency:500
VRM Over Temperature Protection: Disabled
CPU Power Duty Control: T.Probe
VCore MOS voltage Control: Auto
CPU Power Phase Control: Extreme
CPU Vcore Boot Up Voltage: Auto
VCCSA Load-Line Calibration(LLC): High
VCCSA Current Capability: 100%
VCCSA Fixed Freq: 300
CPU VCCSA Boot Up Voltage: Auto
CPU VTT Switching Freq: 1.3x
CPU VTT Over-Current Protection: Disabled
DRAM-AB Current Capability: 100%
DRAM-AB Voltage Frequency: Manual
DRAM-AB Fixed frequency:350
DRAM-AB Power Phase Control: Optimized
DRAM-CD Current Capability: 100%
DRAM-CD Voltage Frequency: Manual
DRAM-CD Fixed frequency:350DRAM-CD Power Phase Control: Optimized
PCH Switching Freq: 1x

CPU Performance Settings Submenu:
CPU Ratio: auto
Enhanced Intel Speedstep Technology: Disabled
Turbo mode: Enabled
Power Limit Control: Auto

Advanced Menu
CPU Configuration Submenu:
Intel Adaptive Thermal Monitor: Disabled
Hyper-threading: Enabled
Active Processor Cores: All
Limit CPUID Maximum:
Execute Disable Bit: Enabled
Hardware Prefetcher: Enabled
Adjacent Cache Line Prefetch: Enabled
DCU Streamer Prefetcher: Enabled
DCCU IP Prefetcher: Enabled
Intel Virtualization Tech: Enabled

CPU Power Management submenu
CPU Ratio: Auto
Enhanced Intel Speedstep Technology: Disabled
Turbo mode: Enabled
CPU C1E: Enabled
CPU C3 Report: Disabled
CPU C6 Report: Disabled
CPU C7 Report: Disabled

Monitor Settings
Anti Surge Support: Disabled

 

[vZeeKHD]

Cerca di limare un po il voltaggio della cpu :sisi: per il resto mi sembra ok, anche le temp sembrano buone :)

 

[Extreme™]

Il Vcore secondo me è alto per daily use.....;)

 

[Ramqage]

Il Vcore secondo me è alto per daily use.....;)

D: quindi per evitare bsod e superare un pò di IBT come dovrei procederei tra voltaggi e le altre configs ?

 

[Furlans]

Scendi sul core fino a che ibt Non ti da stabile

- - - Updated - - -

Scendi sul core fino a che ibt non ti da stabile , cerca di arrivare a 10 runa maximum stabile con minor voltaggio possibile